RMW Techno Scale Models

In development

Nooteboom 3-axle Teletrailer

Wouter is currently working on designing a teletrailer based on ideas gained from the ballast trailer. The trailer is equipped with servo-controlled axle lines, which are controlled by an electronic signal based on the position of the trucks dish in relation to the trailer.

The technique for generating the correct signal for deflection and center position has been developed by Marc and has been solved mechanically so that a natural steering movement is made and no expensive prints are required.

Due to increasing electronic variants for controlling axles (such as DTAS and… ..) this system has been referred to as the Zado system (without all that nonsense).

The trailer is an addition to the fleet of Richard and will be used to transport boom sections of the LR 1750.

Technical details:

Length retracted:     930 mm
Length extended: 1475 mm
Width:                          175 mm
Mass:       not yet known kg
Load capacity:        +/-15 kg

Under construction

Broshuis SL2 5-axle semi

While work on the LR continues, Richard is busy making drawings of a 5-axle semi. Just like the 3-axle teletrailer, the trailer is equipped with servo-controlled axle lines.

The trailer is intended to be able to transport the heavier parts of the LR 1750 during an exhibition. For some parts it must be possible to extend the trailer

Technical details:

Length retracted:   893 mm
Length extended: 1384 mm
Width:                       174 mm
Mass:                      +/- 5 kg
Load capacity:           25 kg